Covered Product Category: Residential Central Air Conditioners

ENERGY STAR Qualified Products

FEMP provides acquisition guidance across a variety of product categories, including residential central air conditioners (CACs), which are an ENERGY STAR®-qualified product category. Federal laws and executive orders mandate that agencies meet these efficiency requirements in all procurement and acquisition actions that are not specifically exempted by law.

Most manufacturers display the ENERGY STAR label on complying models. For a model not displaying this label, check the manufacturer's literature to determine if it meets the efficiency requirements outlined by ENERGY STAR.

This product category overview covers the following:

Performance Requirements for Federal Purchases

For the most up-to-date efficiency levels required by ENERGY STAR, look for the ENERGY STAR label or visit the ENERGY STAR Product Specifications website. For more information, contact the FEMP point of contact listed at the bottom of this page.

Back to Top

Buying Energy-Efficient Central Air Conditioners

Loading the player ...

ENERGY STAR's Product Specification applies to central air conditioners that operate on single-phase current and have cooling capacities less than 65,000 Btu/h. Room air conditioners (window and through-the-wall) are covered by a separate specification, and packaged terminal units are excluded. For CACs purchased directly from commercial sources, specify or select products that are ENERGY STAR-qualified. To find qualified CACs, go to the Consortium for Energy Efficiency (CEE) and Air Conditioning and Refrigeration Institute's (ARI) online directory. A guide explaining how to use this directory is available.

The seasonal energy efficiency ratio or SEER is shown on the yellow EnergyGuide label required on these products. The energy efficiency ratio (EER), which is considered a better measure for determining peak load, can typically be found in the manufacturer's product literature or website.

The Federal supply source for CACs is the General Services Administration (GSA), which sells them through its Multiple Awards Schedules program and online shopping network, GSA Advantage! Note that not all CACs sold through GSA are ENERGY STAR-qualified, and some products that do qualify may not be indicated as such. When buying CACs through this source, check the models you are considering against the CEE/ARI Directory.

These requirements apply to all forms of procurement, including guide and project specifications; construction, renovation, repair, energy service, operation and maintenance (O&M) contracts; lease agreements; and solicitations for offers. Energy performance requirements should be included in all evaluations of solicitation responses. Buyers shall insert the standard clause from FAR section 52.223-15 into contracts and solicitations that deliver, acquire, furnish, or specify energy-consuming products for use in Federal facilities. Agencies can claim an exception to these requirements through a written finding that no ENERGY STAR-qualified or FEMP-designated product is life-cycle cost effective for a specific application.

Back to Top

Buyer Tips

Federal buyers should require that CACs be installed in accordance with the HVAC Quality Installation (QI) Specification published by the Air Conditioning Contractors of America. Installation problems like oversizing, improper charging, and leaky ducts result in efficiency losses, occupant discomfort, and shortened equipment life. Requiring the contractor to follow the HVAC QI Specification will assure that these and other problems are addressed and that the energy and cost savings are achieved.

Refrigerants with ozone destroying hydrochlorofluorocarbons (HCFCs) were commonly used in CACs until recently. When retiring CACs that contain HCFCs, the Clean Air Act requires that certified technicians recover the refrigerant on-site and dispose of it in an environmentally-friendly manner.

Back to Top

User Tips

Consider leaving CACs off during unoccupied hours, or using a programmable thermostat to minimize unnecessary operation of the unit. Regular maintenance (e.g., charging refrigerant, replacing filters, etc.) is necessary to maintain peak performance.

Back to Top

Estimating Energy and Cost Savings

ENERGY STAR has an Excel-based cost calculator for CACs. To modify the utility price, click on "Savings Calculator" in the column on the right and input the SEER and capacity of the CAC and the rate for electricity at your facility. The output section will automatically display results that more accurately reflect your energy use and cost.

Back to Top

For More Information

Federal supply sources are the U.S. General Services Administration (GSA) and Defense Logistics Agency (DLA). GSA sells products through its Multiple Awards Schedules and GSA Advantage! DLA offers products through the Defense Supply Center Philadelphia and DOD EMALL.

The following resources are available for additional information:

Amanda Sahl
Federal Energy Management Program
202-586-1662
amanda.sahl@ee.doe.gov

Lawrence Berkeley National Laboratory provided supporting analysis for this acquisition guidance.

Back to Top